Update history to the Twizy PowerBox BT made by Kenneth Nilsen Email: kennethnilsen69@gmail.com

V1.61
1. Fixes that it would not stop charging at the desired SOC level.
2. has made an improvement the display of live info numbers. more stable.

V1.60
1. a small stability improvement
2. Powerbox BT with serial number 196930285 and up now has a BLE module from another factory with little difference in the firmware so there is now another way to initialize them. 
   Should not affect the customers anything other than that they Powerbox BT from this SN number can not use older Powerbox versions then v1.60

V1.58
1. Prepared for Android App v0.90
2. Improved CAN-Bus communication

V1.57
1. Fixed an issue for iOS first time connection.
2. added SOH to BT API (The app is not ready for this yet)

V1.55
1. T80 can now drive again without the Power Box Connected. (You must first reset it to original tuning and then tune it again with desired tuning selection)

V1.54
1. T45 can now drive again without the Power Box Connected. (You must first reset it to original tuning and then tune it again with desired tuning selection)

V1.53
1. Fixed a problem with Twizy model recognition. it did not always understand that it was connected to a T45.

V1.51
1. Fixed a problem with the BMS function in the Powerbox. this gave a choppy acceleration at high SOC. (at SOC over 96% and low temp) 

V1.50
1. It is now possible to tune your Twizy without an app by only using the remote control. You can choose between Medium, MaxPower and Original Tuning.

How it is done:
1. Switch OFF the PowerBox with the switch on the Y cable.
2. Start your Twizy.
3. Turn ON the PowerBox.
4. When all 3 LEDs light up, hold down the red D button and hold it until all three lights up again and then release the button.
5. Now the red and yellow diode flashes and you are now in the Tuning Menu.

The button functions in Tuning Menu are:
A = Medium Tuning
B = maxPower Tuning
C = Original Tuning
D = Exit Tuning Menu
6. Select the desired tuning option and wait until the red and yellow diode stops illuminating.
7. Turn OFF and ON the ignition key and you are ready to drive.

PS: If you select original tuning then the diodes will not turn off because the PowerBox must be disconnected after a reset. 
Just wait until the Service lamp disappears and you can disconnect the Power Box. Then OFF and ON with the ignition key and you are ready to drive

V1.40
1. Some small minor fix.

V1.30
1. Adjusted ECO Mode so that it is now completely identical to Original Tuning in Medium og maxPower Tuning

V1.20:
1. Some small minor fix.

V1.10: 
1. First release